Monday, 10 December 2018

How to use AUTO Constraint in CATIA V5?

AUTO Constraint in CATIA V5: Auto constraint is used to provide the constraint to the sketch. The constraints may be fixed constraint, length, angle, radius, diameter constraint etc. which are used to make the components stick at a position with respect to the coordinate system. In this article, I am going to explain the usage of AUTO Constraint in CATIA V5 in a detailed manner. The step by step procedure is to be needed to adopt the usage of AUTO Constraint in CATIA V5 and is as follows.

AUTO Constraint in CATIA V5-Procedure:

To use Auto Constraint in CATIA V5,
  • Take any plane (Say XY Plane).
  • Now draw the lines which may/may not join at the common point.
  • After it, click on the Constraints button and choose the desired.
  • Let it may be, the length of the section, fixing the section, coinciding the lines, tangency etc.

                          That’s it…this is the Auto Constraint which can adapt automatically w.r.t the situations.



Post a Comment